Volume 2, Issue 4, December 2017, Page: 150-161
A PC Based Cost Effective Advanced Cardio Signals Monitoring System
Anamika Bose, Department of Electrical and Electronic Engineering, Bangladesh University of Engineering and Technology, Dhaka, Bangladesh
Saleh Ebn Sharif, Department of Electrical and Electronic Engineering, Bangladesh University of Engineering and Technology, Dhaka, Bangladesh
Akanksha Sinha, Department of Bio-informatics, West Bengal University of Technology, Calcutta, India
Received: Aug. 12, 2017;       Accepted: Aug. 30, 2017;       Published: Sep. 23, 2017
DOI: 10.11648/j.bsi.20170204.14      View  1575      Downloads  139
Abstract
In this paper, a low cost and simple portable PC based ECG monitoring system was presented. The main aim of this project is to implement a simple ECG monitoring system in laboratory conditions using components available in the local market. Normally, in twelve leads ECG, Lead-2 offers the most valuable information to diagnose the heart condition. In this project, Lead-2 is implemented in hardware together with computer interfacing. Twelve leads machine can be made simply using the same circuit twelve times for each lead or time division multiplexing with corresponding increase in complicacy. The electrical signal obtained and processed from circuit was fed to sound card of the computer through audio port and then, signals were shown using built-in virtual oscilloscope of MATLAB named soft scope. The detailed circuit development, noise reduction, filtering and installation, as well as the results, are presented.
Keywords
Electrocardiography, Biomedical Monitoring, Heart Rate, ECG, Virtual Oscilloscope, Interfacing
To cite this article
Anamika Bose, Saleh Ebn Sharif, Akanksha Sinha, A PC Based Cost Effective Advanced Cardio Signals Monitoring System, Biomedical Statistics and Informatics. Vol. 2, No. 4, 2017, pp. 150-161. doi: 10.11648/j.bsi.20170204.14
Copyright
Copyright © 2017 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Reference
[1]
Cromwell, Leslie, Fred J. Weibell, and Erich A. Pfeiffer. Biomedical instrumentation and measurements. Prentice Hall, 1980.
[2]
Webster, John G. "Medical Instrumentation-Application and Design." Journal of Clinical Engineering 3, no. 3 (1978): 306.
[3]
Khandpur, Raghbir Singh. Handbook of biomedical instrumentation. Tata McGraw-Hill Education, 1992.
[4]
Carr, Joseph J., and John Michael Brown. Introduction to biomedical equipment technology. Prentice Hall, 1993.
[5]
Clifford, Gari D. "Advanced methods and tools for ECG data analysis." (2009).
[6]
Acharya, Rajendra, Shankar M. Krishnan, Jos AE Spaan, and Jasjit S. Suri, eds. Advances in cardiac signal processing. Berlin: Springer, 2007.
[7]
Clifford, Gari D. "Signal processing methods for heart rate variability." PhD diss., University of Oxford, 2002.
[8]
Hu Y. H. Shen T. W., Tompkins W. J.,―One-lead ecg for identity verification,‖ Proc. IEEE EMBS/BMES Conf,, pp. 62–63, 2002.
[9]
Abilashini, N., et al. "ECG Signals for Personal Identity Verification." (2014).
[10]
A. R. Houghton and D. Gray. “making sense of the ECG”., Hodder Arnold Publishing.m 2003.
[11]
Online Article Available at: http://www.eng.utah.edu/~jnguyen/ecg/ecg_index.html
[12]
Yagoub, K. M. S., Mohammed, M. R., & Ali, T. M. M. (2016). Microcontroller Based ECG Arrhythmia Biosimulator for Testing ECG Machines (Doctoral dissertation, Sudan University of Science and Technology).
[13]
Jemilehin, Tosin, and Michael Adu. "Design and Simulation of Electrocardiogram Circuit with Automatic Analysis of ECG Signal." Analele Universitatii'Eftimie Murgu' 23. 1 (2016).
Browse journals by subject